Home made Pi plate case

Home made Pi plate case

John has shared with us a DIY enclosure for his Raspberry Pi 3.

John writes:

Hello LittleBird.

When speaking to Marcus, I was asked to show the home made "case" my Raspberry Pi 2 resides in.  This is a very simple solution to providing some static security and plenty of cooling, although a heat sink has also been applied to the SOC.  There are other "plate case" solutions available commercially, but all seem to be overly elaborate and expensive - this one was cheap and fun to make.

The sheet metal is from a small, .5mm thin, plate of aluminium obtained from Bunnings, and carefully cut and filed to size and shape without creating a bend in the plate (there is plenty of it left for further ideas).  The top plate ended up being cut back to clear the top lips of the USB connectors rather than making the solution higher; which would have been difficult with the screws used.  Small, thin, self-sticking rubber patches were stuck onto the bottoms of the screws to avoid scratching the surface the Pi rests on.

As an expression of paranoia about shorting the various through-hole elements, the top surface of the bottom plate is not painted, it is covered in two coats of black "Liquid Electrical Tape" from Jaycar Electronics to ensure the plate itself cannot contact any live wires.  I had a can of flat black spray enamel for the other surfaces.

Most of the time this Pi is now running as a 24x7 pico-server, using a fast 32GB micro SD card for the OS and a 1TB USB drive for the data.  It may not be all that fast, but following the last round of updates to Ubuntu 16.04, it is superbly reliable; and now my QNAP NAS is only started up to provide a RAID-protected backup location!


We really like the simplicity and elegance of this design.

Previous article Introducing learn.littlebirdelectronics.com
Next article The new Raspberry Pi Zero is available now!